This lets GXPicture see them, but does not allow the use of the sensor.
From the Apteryx Updates Page install the Gendex Imagingextension.įor legacy software please use the Legacy Downloads page, use the Creating Layouts and set the source as Gendex Imaging on step 11.ĭuring installation make certain that the KaVo Software Manager also installs the KaVo IO Sensor Driver 1.0.9 or higher as it is necessary for the sensor to function correctly.If the sensor is a Dexis Sensor, and was working within the Dexis Imaging software on the current PC prior to using the sensor in Apteryx software, the Dexis drivers built into Dexis Imaging are most likely locking the sensor to themselves.
Configure Sensor Image Quality Settings. If you run into issues installing the correction files for any sensor, please contact KaVo Support for further assistance. Note: An example sensor folder for the Dexis Platinum sensor could be C:\Program Files (x86)\Gendex\ GXS700_CorrectionFiles, but if the GXS700_CorrectionFiles folder does not exist, it would need to be created. ( For 32-bit Windows:) C:\Program Files\Gendex\ ( For 64-bit Windows:) C:\Program Files (x86)\Gendex\ 
The install directory for the calibration files will need to be changed to the hardware specific Correction Files folder within the Gendex directory found in:. Install the sensor correction/calibration file(s) from the CD that came with the sensor:. Note: If you run into issues installing GxPicture, please contact KaVo Support for further assistance. At the GxFilter section, enable filters associated with installed hardware. Select your device(s) at 'Select Features' screen. Select " Other Software - GXPicture Filters Enabled". Go to the Driver Downloads page, and download the GxPicture (Web Installer). The DexCam 3 ( GXC-300) uses the DirectVideo extension, and the hardware capture button is not supported. The Dexis Carivu camera is not currently supported.
0 kommentar(er)
